Getting started using Cura slizer with Duet3D
This post is about getting started using Ultimaker Cura with your Duet3D controller.
This post is about getting started using Ultimaker Cura with your Duet3D controller.
So, it’s been a while since Duet 3 was released, but only recently has the accompanying RepRapFirmware (RRF3) gone from RC (Release Candidate / Beta) […]
Been a while since I last wrote about the wonderfull controllers from Duet3D, so, seeing as we just had Black Friday, and E3D-online had a […]
Some time ago I bought the, at the time, new E3D Chimera+ Watercooled hotend and some extra stuff for it. (sorry, misplaced photo of unpacked […]
In a previous post we connected our BLTouch sensor physically to the Duet hardware and made some basic configurations as well. In this post I’ll […]
In this post I’ll continue describing what is needed to actually build the xBot-Medium printer. Last time I talked about the Custom Parts, and this […]
In this post I’ll start describing what is needed to actually build the xBot-Medium printer. I’ve set up a xBot-Medium Github Repository where the files […]
Guess we’ve all tried it.. just can’t get the WiFi to connect to our home network. Especially after a firmware upgrade. For some reason the […]
I originally planned to use 3 seperate Z-motors for my BeTrue3D Printer project back last christmas, but since I’m using some special hollow Nema 17 […]
Since I just changed my old cartridge for a 24v 80w heater on my 5way Diamond hotend and used High Temperature Liquid Gasket Silicone as […]