xBot Medium – Electronics and Electrical parts (BOM cont.)
In this post I’ll continue describing what is needed to actually build the xBot-Medium printer. Last time I talked about the Custom Parts, and this […]
Category: Duex5
xBot Medium – Look at materials (custom BOM)
In this post I’ll start describing what is needed to actually build the xBot-Medium printer. I’ve set up a xBot-Medium Github Repository where the files […]
Duet WiFi/Eth – Use M584 to autolevel or sync Z-axis using 2 or more motors
I originally planned to use 3 seperate Z-motors for my BeTrue3D Printer project back last christmas, but since I’m using some special hollow Nema 17 […]
BLTouch on Duet Wifi & RepRapFirmware
The time has come to setup BLTouch on my system. I’m going to use Duet WiFi + Duex5, but I’ll post details about using it […]
Duex5 – Use build in 12v switching regulator on 24v system
Index Use Duex5 to get 12v Jumper settings Configure LED in firmware Further customization options All done Use Duex5 to get 12v As far as […]