Duet (2) WiFi – Getting started
Been a while since I last wrote about the wonderfull controllers from Duet3D, so, seeing as we just had Black Friday, and E3D-online had a […]
Been a while since I last wrote about the wonderfull controllers from Duet3D, so, seeing as we just had Black Friday, and E3D-online had a […]
Some time ago I bought the, at the time, new E3D Chimera+ Watercooled hotend and some extra stuff for it. (sorry, misplaced photo of unpacked […]
In a previous post we connected our BLTouch sensor physically to the Duet hardware and made some basic configurations as well. In this post I’ll […]
Guess we’ve all tried it.. just can’t get the WiFi to connect to our home network. Especially after a firmware upgrade. For some reason the […]
I originally planned to use 3 seperate Z-motors for my BeTrue3D Printer project back last christmas, but since I’m using some special hollow Nema 17 […]
Since I just changed my old cartridge for a 24v 80w heater on my 5way Diamond hotend and used High Temperature Liquid Gasket Silicone as […]
In this post I’ll go through updating firmware on the PanelDue. It’s really not that difficult, but as always, it can be a bit of […]
As some might know, I’ve been working on a version 4 of my Belted Extruder and am now ready to put it to use on […]
Note: This post is not complete, and the temperature settings in startup.gcode is not correct for use in Cura – I am working on a […]