Duet WiFi/Eth – Recover from Erase + basic setup
I accidentially hit the Erase button on the edge of my Duet WiFi card, which means it wiped my firmware from the controller! Luckily it […]
Category: Duet3D
PanelDue – Update firmware
In this post I’ll go through updating firmware on the PanelDue. It’s really not that difficult, but as always, it can be a bit of […]
Duet WiFi – Adding a second extruder
As some might know, I’ve been working on a version 4 of my Belted Extruder and am now ready to put it to use on […]
Using Duet with Cura and + Diamond Hotend and Firmware Retract
Note: This post is not complete, and the temperature settings in startup.gcode is not correct for use in Cura – I am working on a […]
BeTrue3D Printer – Setting up 5-way Diamond firmware
Wow, been a while since I last wrote… seems like I always start by writing that, hehe. As always I’ve been through a lot of […]
RPi Zero Wireless – Video for Duet using MotionEYE OS
Prelude Just the other day I wrote the post on setting up Video on the RPi Zero W to use on the Duet. This post […]
Raspberry Pi Zero Wireless – Video for Duet
For this project I’m going to use one of the tiny Raspberry Pi Zero Wireless controllers and a Pi NoIR Camera V2. Using the NoIR […]
BLTouch on Duet Wifi & RepRapFirmware
The time has come to setup BLTouch on my system. I’m going to use Duet WiFi + Duex5, but I’ll post details about using it […]
Duex5 – Use build in 12v switching regulator on 24v system
Index Use Duex5 to get 12v Jumper settings Configure LED in firmware Further customization options All done Use Duex5 to get 12v As far as […]
BeTrue3D Printer build part 9 – LEDs – 12v from 24v Duex5
Finishing our LED installation We previously installed front LEDs, including an on/off rocker. Recap: Back then, I only had 12v LED strips and as I […]